Plastic sandblas media

Sandblast plastic media Alumina, glass beads, silicon carbide, silicon carbide, steel, copper beads,

Plastic blasting media 

Plastic abrasives deliver a high stripping rate and consistent performance, ideal for paint stripping, mold cleaning, deflashing and deburring.Sandblasting, using compressed air, is traditionally used to prepare surfaces for coatings. The sharp particles of aluminum oxide or other media abrade the surface. Incidental corrosion, rust, and old coatings are removed in the process, leaving a good surface for paint adhesion.However, substrates other than steel can often not tolerate this aggressive surface preparation and, as a consequence, wet chemical strippers are employed to remove coatings. Aluminum, brass and plastic composites, including fiberglass, are often treated in this way.Using plastic abrasives has been proven to significantly reduce the generation of hazardous waste that using wet chemical strippers can cause. In addition, the use of plastic abrasives has proven to be faster, less damaging to the substrate and much less expensive than wet chemicals. Since the plastic abrasive is harder than the coatings to be removed, yet softer than the substrate, coatings can actually be stripped three or four times without damage to the surface.Plastic abrasives are sensitive to substrates, including aluminum and other delicate metals, composites and plastics, yet tough enough to take care of the most demanding decoating and surface finishing needs efficiently.Consider the size of perforations or holes through which the plastic abrasive must pass when screen separating parts from media after use.

Mesh Description

8-12 mesh / 1.70-2.36 mm

10-20 mesh / 0.85-2.00 mm

12-16 mesh / 1.20-1.70 mm

16-20 mesh / 0.85-1.20 mm

20-30 mesh / 0.56-0.85 mm

30-40 mesh / 0.42-0.56 mm

40-60 mesh / 0.25-0.42 mm

60-80 mesh / 0.16-0.25 mm

Recyclable. Call for details.

 Alumina, glass beads, silicon carbide, silicon carbide, steel, copper beads, ceramic sand, sand aluminum, plastic sand, resinsand, sand and other user-walnut process requirements based on product selection.

Plastic sandblas media